[argyllcms] Re: compiling V1.3.3beta on win7

Hi,

Am 16.04.2011 10:24, schrieb tmwu:

Hello:
Following Don Craig’s procedure posted on Feb. 2, 2011,
Looked through it, wow, 20 steps total :) As well-intentioned as the instructions may be, they seem a bit convoluted (no offense of course, recording this all and writing it up surely was a lot of work, let alone going through it all).
The only 'tricky' part I've found when compiling Argyll with ftjam and mingw (after making sure to include g++ when installing mingw) is to setup three environment variables correctly. Then you can just call the makeall.bat, then install.bat, in the Argyll source directory, and it should build and collect the binaries in the 'bin' folder. 

http://www.freelists.org/post/argyllcms/Compiling-from-source,7


I can compile V1.3.2 on Win7. However, the same procedure
does not work in my computer. A colprof.exe is produced,
but can not run.
Any suggestions are welcome.
tmwu


--
Florian Höch

Other related posts: