From Installing_MSWindows.html (v1.1.1):"NOTE that you generally can't install USB drivers on Vista 64/Windows 7 64 bit due to Microsoft's driver code signing requirements."
So, I think you either need to put the system in test mode and self-sign the drivers before installation (that's what I did, works nicely) or (not so nice) press F8 on each boot.
Regards Am 20.06.2010 22:24, schrieb nino@xxxxxxxx:
Florian, I didn't have to do the F8A workaround, because I did a fresh install of the Argyl LibUSB driver. As detailed in the Argyll installation instructions, it is not necesary to do the driver signing/test mode/F8 in Win7 when freshly installing. There was no problem. It worked as described in the Installation Instructions. Also, as mentioned the driver Argyll LibUSB driver shows up in the Device Manager. -----Original Message----- From: argyllcms-bounce@xxxxxxxxxxxxx [mailto:argyllcms-bounce@xxxxxxxxxxxxx] On Behalf Of Florian Höch Sent: Sunday, June 20, 2010 11:16 PM To: argyllcms@xxxxxxxxxxxxx Subject: [argyllcms] Re: [argyllcms] Hi, have you followed the driver signing/test mode/F8 boot procedure that is necessary for the Argyll Win7 64 drivers like outlined on this list a while ago? I assume so, as you were able to install the driver. Just checking. Am 20.06.2010 21:24, schrieb nino@xxxxxxxx:Yes, Roger, I double checked: DTP94 is linked to Argyll LibUSB driver. When I try to run dispcal for example I get "Error - icoms - set_ser_port: port number out of range!" nino *From:* argyllcms-bounce@xxxxxxxxxxxxx [mailto:argyllcms-bounce@xxxxxxxxxxxxx] *On Behalf Of *Roger Breton *Sent:* Sunday, June 20, 2010 10:18 PM *To:* argyllcms@xxxxxxxxxxxxx *Subject:* [argyllcms] Re: [argyllcms] Whew? Windows 7 64 bit giving you USB issues? You’re sure you have the instruments linked to the Argyll LibUSB driver, and not X-Rite’s? Did you look into Computer – Manage – Devices? Roger *From:* argyllcms-bounce@xxxxxxxxxxxxx [mailto:argyllcms-bounce@xxxxxxxxxxxxx] *On Behalf Of *nino@xxxxxxxx *Sent:* 20 juin 2010 09:23 *To:* argyllcms@xxxxxxxxxxxxx *Subject:* [argyllcms] Hi, I am trying to run Argyll, but the communication port of my device, a DTP94b, is not found when I try dispcal (Under -c listno I get ** No ports found **). I uninstalled the device completely before installing it from scratch with the Argyll driver for win7 64bit. Didn't help. thanks in advance for any help nino
-- Florian Höch http://hoech.net