[argyllcms] Re: RGB Printer profiling and ColorSavvy CM2C

Hi Greg,

Greg Sullivan wrote:

I used the 'fakeread' command to create a dummy TI3
file, discarding the measurements and replacing them with the real
measurements. IMPORTANT: After you have created the TI3, ensure that the
DEVICE_CLASS is set to "OUTPUT" if you wish to create perceptual
tables.  (if DEVICE_CLASS is set to "DISPLAY", the profile command
will ignore any request to create the perceptual tables)

Thanks for that hint. What I did last night was to use the scanner-based target reading to create the ti3 file - partly because I was curious to see just how well it performed compared with the colorimeter. Unsurprisingly, it performed far better in light areas than dark areas (which it generally over-estimated)

All the best,
--
Alastair M. Robinson

Other related posts: