[argyllcms] !_Printcal don't create .AMP file.

I'm using printcal command like that:
"printcal -v -i -x 6 75 -x 7 85 -x 5 80 -a MC_Voda"

.cal file created, but without .AMP. A really need it in case of gutenprint
cannot use 8 channel linearization curves at the same time :(

I was tried "printcal -v -i -x 6 75 -x 7 85 -x 5 80 -aSomeFileName MC_Voda"
but no result.

I understand that could apply .cal file to targen new multichannel targets.
But in my schedules to construct multichannel the profile, and in the
subsequent I do not represent as to apply the profile to a photo. I as
understand that when I will make multichannel profile I can apply cctiff
with .cal, but it would be desirable to avoid superfluous step of saving of
a photo a file after editing, аnd to print directly from Photoshop.

BTW attempt of profiling Epson R2400 (CcMmYKlkllk - DYE) InkSet as
multichannel is only experiment. Naturally it would be much easier to
profile this InkSet as usual CMYK. But further usage of the extremely
experimental and non-standard InkSets, like CMYKRGBO (I think) is supposed.

-- 
C уважением,
Дмитрий Чаплыгин.
+7 (495) 979-8412
Skype: Chapa75
ICQ: 3167277

Other related posts: