Yeah, good idea. Try profiling alone. Just to see what kind of results you get. / Roger From: argyllcms-bounce@xxxxxxxxxxxxx [mailto:argyllcms-bounce@xxxxxxxxxxxxx] On Behalf Of Martin Sivak Sent: 20 juin 2010 07:55 To: argyllcms@xxxxxxxxxxxxx Subject: [argyllcms] Re: DispcalGUI problem Hi, I noticed that also. When you stop after calibration and request profiling only, does it return correct results? Or just try doing calibration and profiling in two steps. It seems to me that dispcalGUI tries to send the key to make the whole calibration/profiling sequence unattended, but since dispcal requests another device calibration it accidentally calibrates the instrument with gray patch from the display. Martin Sivak On 20.6.2010, at 11:17, Marco N. wrote: I have tried many times with a lot of interface set up, the luminance is always on maximal (I have tweak it in the Mac preferences to 120 cd/m2) I have a strong double. After the calibration the instrument requests the second internal calibration. This internal calibration is carried out by the software automatically on display ( and then I have to push a key to perform the color measurement) Place cap on the instrument, or place in on a dark surface, or place on the white calibration reference, and then hit any key to continue, or hit Esc or Q to abort: Calibration complete Is it normal? I have the double that the instruments calibrates itself on the white of display and takes the measurements incorrectly ... Thank you Marco Il giorno 20/giu/2010, alle ore 10.38, Marco N. ha scritto: Is there a luminance auto adjustment? Where? Thank you everybody Marco Il giorno 20/giu/2010, alle ore 10.14, Fabrizio Levati ha scritto: I know it sounds like a dumb question but, is the luminance auto adjustment turned off? Cheers Fabrizio