[argyllcms] Re: DTP20 (Pulse) patch size error

The DTP20 now is recognized by argyllcms, but it won't read the patches.
All I can get are:
Strip read failed due to misread (Invalid strip patch size was detected,
Re-scan)
That's using the default patch size.  From what I understand the -a switch
will increase both height and width, but this is device dependent.  When I
use the -a switch however, I don't see any change in patch size?  The
patches Argyll is printing are considerably smaller than ColorPort,
ColorElite or MonacoProfiler.

How can I print targets with patch sizes that match the X-rite originals?

Phil
 
-----Original Message-----
From: argyllcms-bounce@xxxxxxxxxxxxx [mailto:argyllcms-bounce@xxxxxxxxxxxxx]
On Behalf Of Alan Goldhammer
Sent: Friday, August 12, 2011 4:52 PM
To: argyllcms@xxxxxxxxxxxxx
Subject: [argyllcms] Re: Opening USB port failed (Philip Reed)

My reading of the documentation is that '-a' only makes the patches longer
in the read direction but does not affect the height.  Perhaps Graeme can
confirm this.

Alan

-----Original Message-----
From: argyllcms-bounce@xxxxxxxxxxxxx [mailto:argyllcms-bounce@xxxxxxxxxxxxx]
On Behalf Of Philip Reed
Sent: Friday, August 12, 2011 4:26 PM
To: argyllcms@xxxxxxxxxxxxx
Subject: [argyllcms] Re: Opening USB port failed (Philip Reed)

Hi Juergen,

You're absolutely brilliant!  I updated the driver and pointed it to the
Argyll directy...problem solved!  Thank you!

Now...any idea how to make the patches a bit bigger?  Not sure if I'm
implementing the -a switch properly.

Regards - Phil Reed

-----Original Message-----
From: argyllcms-bounce@xxxxxxxxxxxxx [mailto:argyllcms-bounce@xxxxxxxxxxxxx]
On Behalf Of Juergen Lilien
Sent: Friday, August 12, 2011 1:51 PM
To: argyllcms@xxxxxxxxxxxxx
Subject: [argyllcms] Re: Opening USB port failed (Philip Reed)

(Appropriate thread subject line added ;-)


Hello Philip,

have you checked in Device Manager that the Argyll USB Device driver
(not the original XRite one) is active for the DTP20?

Regards, Juergen

Other related posts: