[arachne] Re: New Arachne release....

Arachne at FreeLists---The Arachne Fan Club!

On Thu, 10 Jul 2008 14:04:01 -0800, Ray Andrews wrote:

> Arachne at FreeLists---The Arachne Fan Club!

> On Thu, 10 Jul 2008 19:32:01 +0100, Bastiaan Edelman wrote:

> Bastiaan,

>> Since I am no longer on dial-in phone connection I left "connection"
>> blank in arachne.cfg (and tried "ready") but arachne only is trying to
>> initialize TCP/IP at vector 0x60 which fails.

> If you pre-load your packet driver then this should be what you need:

> Connection [blank] >>>>> Is your keyword: connection or connect?
> Base [blank]
> WATTCP myfiles\wattcp.cfg
> LSPPP [blank]

Changed this but still: "Unable to initialize TCP/IP at vector 0x60"

> Then, it's just a question of getting the right settings into wattcp.cfg.
> The setup routine takes you to a page for editing wattcp.cfg or do it

The setup button points to file://setup.htm and this file is NOT present
in your distro.

> manualy, but you must put *all* connection information in there, nothing
> is done with keywords anymore. There are a few examples, but probably
> you need just:

> my_ip=dhcp

> Ron and Glenn use my distro with network cards with no problem.

In 1.93 I had to mention in arachne.cfg:
=======================
IP_Address 192.168.1.65
IP_Grap IP address set to
NameServer 192.168.1.254
AltNameServer 0.0.0.0
Gateway 192.168.1.254
AltGateway 0.0.0.0
Netmask 255.255.255.0
TCPconfig LANTCP.CFG
=====================

Where do I suppose to store these details?
I put them into wattcp.cfg but still no positive results.

Regards, Bastiaan
-- This mail was written by a user of the Arachne Browser - http://arachne.cz/
                  Arachne at FreeLists                  
-- Arachne, The Premier GPL Web Browser/Suite for DOS --

Other related posts: