Arachne at FreeLists---The Arachne Fan Club!
On Thu, 10 Jul 2008 19:32:01 +0100, Bastiaan Edelman wrote:
Bastiaan,
> Since I am no longer on dial-in phone connection I left "connection"
> blank in arachne.cfg (and tried "ready") but arachne only is trying to
> initialize TCP/IP at vector 0x60 which fails.
If you pre-load your packet driver then this should be what you need:
Connection [blank]
Base [blank]
WATTCP myfiles\wattcp.cfg
LSPPP [blank]
Then, it's just a question of getting the right settings into wattcp.cfg.
The setup routine takes you to a page for editing wattcp.cfg or do it
manualy, but you must put *all* connection information in there, nothing
is done with keywords anymore. There are a few examples, but probably
you need just:
my_ip=dhcp
Ron and Glenn use my distro with network cards with no problem.
> BTW: are u sure the screensaver time is in minutes not seconds in
> arachne.cfg?
Mine is seconds.
Regards,
Ray Andrews
.
-- Arachne;A4a;1n
Arachne at FreeLists
-- Arachne, The Premier GPL Web Browser/Suite for DOS --