This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/1/628.html#000002 Cindy, Grinding noise? Where does it sound like it is coming from? If it seems to be from the back of the machine or deep in the machine then it is probably one of the stepper motors that drive the knife and selector. If it is from the front of the sewing arm then it is in the selector/knife housing. Take off the needle plate. In OS, go into "Maintenence", "Steppers" and in the columns labled "Cutter" and "Selector", left click on the IN and OUT tabs for each one respectively. Watch to see that each one moves in and out freely without dragging and that the push rod wires are connected to the knife and selector. Look at the underneath side of the needle plate, does it look like anything has been rubbing/grinding against the top inside of it? Make sure the knife is installed in it's carrier correctly and that the spring clip that holds the knife carrier assembly is correctly snapped in place. There is a possibility that one of the pushrod wires/cables are bent or kinked and not allowing full movement of the cutter or selector. If everything here is in order then, the problem is probably with the stepper motor assembly's for either the cutter or selector in the rear of the machine which would mean, "tech time.". Rod Springer Amaya Tech & Trainer =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================