[amayausers.com] Re: needle plate broke

This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY 
VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: 
http://www.amayausers.com/boards/ultimatebb.php?/topic/1/218.html#000003

The small raised piece you are referring to is a press fit into the needle 
plate. I suppose that you could do a temporary fix and super-glue it down but 
it does need to be replaced.

Several of the folks on this forum have been using the flat needle plate on the 
standard Amaya and using the presser foot just as you would on flat sewing to 
hold the cap down to prevent flaging. If you want to try this, it is best to 
remove the side wings off the cap driver. The side wings are used with the 
raised needle plate to help level out the curved surface of the cylinder. I 
have tried this and it seems to work just fine.....but get that presser foot 
down to prevent flagging....

Rod Springer
Amaya Tech & Trainer

=========================================================== 

The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list

===========================================================

Other related posts: