[amayausers] Re: hat holder clamp

Roland,

 The description of the clip is for the Wide Angle Conventional Cap Frame. I 
think in the software in the hoop list it is listed as CCF/WAD (Conventional 
Cap Frame/Wide Angle Driver). The description of the bill clip I gave you 
the part number for states it is for the Conventional Cap Frame that fits on 
the Wide Angle Driver. The standard CCF will not fit on the Wide Angle 
Driver, it fits on the CCF (Conventional Cap Frame) Driver. The 2 types of 
drivers are different, and the frames are not interchangeable between them. 
The Conventional Cap Frame and driver was what was sold with earlier Melco 
machines. Melco did not have the Wide Angle or 270 degree stuff until the 
EMT or tubular machines came into existence.

 The part number I gave you should be the right one.

 Jeff Banks
 Melco Embroidery Systems


----- Original Message ----- 
From: "Roland R. Irish III" <signman@xxxxxxxxxxxxxxxxxxx>
To: <amayausers@xxxxxxxxxxxxx>
Sent: Tuesday, February 28, 2006 3:57 PM
Subject: [amayausers] Re: hat holder clamp


Jeff, is this billholder for the WACF or the CCF? The holes
predrilled in the CCF are not the same spacing as the WACF hoop-we
tried. If it is the right one, I'll have to call in an order and get
some if affordable.
Roland

Sunrise Graphics
116 Main St
Claremont, NH 03743
603-543-1324
fax 603-543-9902
www.sunrisegraphics.org
signman@xxxxxxxxxxxxxxxxxxx


On Feb 28, 2006, at 4:54 PM, Jeff Banks wrote:

> HI Roland,
>
>  It is in the Amaya Parts manual that is shipped on CD with the
> machine. It
> is in the Options section of the manual. The part you are looking
> for is
> called "Bill Holder For Conventional Cap Frame for Wide Angle
> Driver". It is
> part number 12180.
>
>  Jeff Banks
>  Melco Embroidery Systems
>
>
> ----- Original Message -----
> From: "Roland R. Irish III" <signman@xxxxxxxxxxxxxxxxxxx>
> To: <amayausers@xxxxxxxxxxxxx>
> Sent: Tuesday, February 28, 2006 1:43 PM
> Subject: [amayausers] Re: hat holder clamp
>
>
>
>> when the tech was up here last week he noticed I used the CCF instead
>> of WACF hooper...we ran off some hats and he showed me the problem.
>> The CCF hoop doesn't have the 'brim' holder that the WACF does. Says
>> he thought it was available from Melco but I don't find anything in
>> the catalog for it. Definitely will make a difference in the hats.
>> Anyone seen this brim clamp for the CCF?
>> Roland
>>
>>
>
>

Other related posts: