[amayausers] Re: amayausers] Foam

I sounds like  your density is not set low enough or not thick enough.  I
just ran some hats with foam and the density was set at a 2.  When at a 2 it
almost cuts the foam for you.



Sincerely,
LiVawne G Moore

Moore Embroidery & Designs
1724 Jerusalem Drive
Round Rock, TX  78664
512-989-0518 Office
512-632-7826 Cell
Moore-Embroidery@xxxxxxxxxx
www.Moore-Embroidery.com




-----Original Message-----
From: amayausers-bounce@xxxxxxxxxxxxx
[mailto:amayausers-bounce@xxxxxxxxxxxxx]On Behalf Of MDallumCO@xxxxxxx
Sent: Wednesday, May 05, 2004 3:00 PM
To: amayausers@xxxxxxxxxxxxxxxx
Subject: [amayausers] amayausers] Foam


Good Afternoon-
Does anyone running Amayas have tips on digitizing and running foam designs?
I have my first request and it is looking pretty good, but when I pull the
foam off, it is not a clean cut - there are jagged edges and pieces that
stick
up through the column or fill.

Any ideas would be greatly appreciated - I need to have a sample and quote
together by tomorrow.

Thanks.

Melissa Dallum

Other related posts: