I have a WACF in the drop down list. There is no XT WACF. I just did it last night. Go to Tools, Hoop set up, custom hoop list. Just look in that drop down box and apply. Wolf Embroidery Wolfemb@xxxxxxxx Lisa and Don Ridley ----- Original Message ----- From: "Mike Garber" <agraphic2@xxxxxxxxxxxx> To: <amayausers@xxxxxxxxxxxxx> Sent: Monday, April 17, 2006 4:08 PM Subject: [amayausers] Re: Visors on XT driver > Anand, > I think I was in hoop setup? There was a list of hoops not on the drop > down list. I selected the XT WACF and its loaded. Sorry, I'm losing my > mind. I'm not at my embroidery computer and I can't remember exactly > how I did it......I'll reply again after I research my steps. > > Mike > > Kesavan wrote: > >>Where is the XT Extended? >> >>Thanks >> >> >> >> >>OK, sewing hats with the WACF hoop selected on the XT machine will give >>you burned bills.... >>The 'XT Extended WACF' hoop selection is not loaded on the drop down >>menu. Once added to the hoop menu and selected the design cannot go as >>low as the WACF hoop and no more hats rubbing. I knew it was me.... >> >>Mike >> >>Mike Garber wrote: >> >> >> >>>Morning, >>> >>>Has anyone sewn a sportsman visor on the XT cap driver. I loaded one up >>>an was able to sew closer to the brim which was exciting. The problem >>>is the visor rubbed on the back of the needle bar and burned a big hole >>>in it. >>> >>>The other thing I'm struggling with is unstructured hats are very loose >>>and wrinkled on the machine. I think its the low needle plate. On the >>>old machine I was able to get away with one piece of 4" tearaway on just >>>a front design. The hat on the new machine has alot of loose material >>>in front of the needle. >>> >>>Anyone? >>> >>>Mike >>> >>> >>> >>> >>> >>> >>> >>> >>> >> >> >> >> >> >> >> >> > > > > > > > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.1.385 / Virus Database: 268.4.2/314 - Release Date: 4/16/2006 >