[amayausers] Re: Question...digitizing and dimensions

I think it has something to do with the design filter.  The AMAYA OS filters
some of the stitches as per the setting you have in the AMAYA OS.  The
design should show the same size in Design Shop and in AMAYA OS, and should
be exactly the size it sews as well, with a little give and take due to
fabric pull.

Aaron Sargent
The Linen Barn
linen@xxxxxxxxxxx
Medford, OR

----- Original Message -----
From: "Rod & Sharon" <springer37@xxxxxxxxxxxx>
To: <amayausers@xxxxxxxxxxxxxxxx>
Sent: Sunday, August 17, 2003 7:03 PM
Subject: [amayausers] Question...digitizing and dimensions


> Hugo, or anyone that may have the answer.....
>
>  I have a question that has been bugging me for some time.
>
> When digitizing in Design shop and then clicking on the Status tab, the
> stitch count will show the number of stitches in the design, right??
>
> Why is it that when opening the design in Amaya and Machine Loading it,
the
> stitch count always reads less ? This difference is anywhere from 700 to
> 2000 stitches and always less than what the same design will show when
> opened up in Design Shop.
>
> The largest difference I have seen is almost 7000 stitches. I am going to
> assume that the design Machine Loaded  in Amaya is the most accurate of
the
> two readings.
>
> One other difference I have noted is with the ruler. If you measure , say
,
> the width of a design and then check the dimensions of this design in
> Properties--Status, the status dimensions always show a larger figure than
> the ruler. Why. ?
>
> It would eliminate a step in digitizing if both the figures matched while
> digitizing. Just curious...
>
> Rod and Shanon Springer
> Embroidery Cottage
> ----- Original Message -----
> From: <HTorbidoni@xxxxxxx>
> To: <Amayausers@xxxxxxxxxxxxxxxx>
> Sent: Monday, January 27, 2003 9:58 PM
> Subject: [amayausers] HELLO
>
>
> > HELLO,
> >
> > My name is Hugo Torbidoni, I was the technical trainer at MELCO until
July
> of
> > 2002 at which time I relocated to West Virginia because my wife's
company
> > offered her a promotion.
> >
> > During the last 2 years with the company I was involved with the final
> > development of the Amaya as well as the ongoing technical training. I
left
> on
> > good terms and upon arriving in West Virginia I became a third party
> > technician for MELCO.
> >
> > I requested to be added to the mailing list to be better informed on
both
> the
> > positive as well as any negative issues that may be occurring with the
> Amaya.
> > I assure you that this is my only intentions and under stand that any
> attempt
> > to promote my business or negative comments made by me would results in
> being
> > removed from the mailing list.
> >
> > I welcome any questions or comments that you may have.
> >
> > Thank You
> >
> >
> > Hugo Torbidoni
> >
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: amayausers-unsubscribe@xxxxxxxxxxxxxxxx
> For additional commands, e-mail: amayausers-help@xxxxxxxxxxxxxxxx
>


---------------------------------------------------------------------
To unsubscribe, e-mail: amayausers-unsubscribe@xxxxxxxxxxxxxxxx
For additional commands, e-mail: amayausers-help@xxxxxxxxxxxxxxxx

Other related posts: