[amayausers] Question...digitizing and dimensions

Hugo, or anyone that may have the answer.....

 I have a question that has been bugging me for some time.

When digitizing in Design shop and then clicking on the Status tab, the
stitch count will show the number of stitches in the design, right??

Why is it that when opening the design in Amaya and Machine Loading it, the
stitch count always reads less ? This difference is anywhere from 700 to
2000 stitches and always less than what the same design will show when
opened up in Design Shop.

The largest difference I have seen is almost 7000 stitches. I am going to
assume that the design Machine Loaded  in Amaya is the most accurate of the
two readings.

One other difference I have noted is with the ruler. If you measure , say ,
the width of a design and then check the dimensions of this design in
Properties--Status, the status dimensions always show a larger figure than
the ruler. Why. ?

It would eliminate a step in digitizing if both the figures matched while
digitizing. Just curious...

Rod and Shanon Springer
Embroidery Cottage
----- Original Message -----
From: <HTorbidoni@xxxxxxx>
To: <Amayausers@xxxxxxxxxxxxxxxx>
Sent: Monday, January 27, 2003 9:58 PM
Subject: [amayausers] HELLO


> HELLO,
>
> My name is Hugo Torbidoni, I was the technical trainer at MELCO until July
of
> 2002 at which time I relocated to West Virginia because my wife's company
> offered her a promotion.
>
> During the last 2 years with the company I was involved with the final
> development of the Amaya as well as the ongoing technical training. I left
on
> good terms and upon arriving in West Virginia I became a third party
> technician for MELCO.
>
> I requested to be added to the mailing list to be better informed on both
the
> positive as well as any negative issues that may be occurring with the
Amaya.
> I assure you that this is my only intentions and under stand that any
attempt
> to promote my business or negative comments made by me would results in
being
> removed from the mailing list.
>
> I welcome any questions or comments that you may have.
>
> Thank You
>
>
> Hugo Torbidoni
>


---------------------------------------------------------------------
To unsubscribe, e-mail: amayausers-unsubscribe@xxxxxxxxxxxxxxxx
For additional commands, e-mail: amayausers-help@xxxxxxxxxxxxxxxx

Other related posts: