[amayausers] Re: Nu-Fit Caps

Thats good you found someone local, save you some shipping.  If that doesn't
work out let me know :)

Aaron Sargent
The Linen Barn
linen@xxxxxxxxxxx
Medford, Oregon
----- Original Message ----- 
From: "Evelyn Runge" <erunge@xxxxxxxxxxxxxxxxxxx>
To: <amayausers@xxxxxxxxxxxxx>
Sent: Tuesday, April 26, 2005 8:16 AM
Subject: [amayausers] Re: Nu-Fit Caps


> Yes, needles are breaking low and also near center seam. I found a local
> embroiderer who is willing to help me out on this one, and I too am saying
> "never again"! Flagging is also a BIG issue. Thanks for the input. Misery
> loves company :~)
>
> Evelyn
>
>
>
>
> > Evelyn,
> > I sewed 48 of those last year and said never again. I had to move the
> design
> > up about 3/8 inch from where I would normally sew it, slow the machine
> down
> > to 800 spm to get them done. My problem was getting them hooped tightly
> > enough to eliminate flagging. Where in the design are you breaking
> needles?
> > If close to the bill, try bending the bill back towards the cap after
you
> > hoop it. This may let the bottom of the cap lay down closer to the
needle
> > plate. Give us more info, one of the GURU'S may be able to assist.
> >
> > Herb
> > Royal Embroidery
> > ----- Original Message ----- 
> > From: "Evelyn Runge" <erunge@xxxxxxxxxxxxxxxxxxx>
> > To: <amayausers@xxxxxxxxxxxxx>
> > Sent: Tuesday, April 26, 2005 5:15 AM
> > Subject: [amayausers] Nu-Fit Caps
>
>

Other related posts: