Hello,
MikeBurckhard has just posted in the Machines & Hardware forum of AmayaUsers
Discussion Boards under the title of programing a stop.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6566-programing-a-stop
Here is the message that has just been posted:
***************
To answer your original question, you can just add a "Pause" in between your
thread colors in your sequence. Dont use the "stop" command - this seems to
mess with my color sequence.
But, I also use the Settings By Color on DesignShop v9. Here are the things I
do to make sure the settings stay put:
1. Stop all other machines while setting up the settings - for some reason, If
i get a thread break or error message while in the "Settings By Color" menu, it
gets buggy.
2. I click apply after every change - seems redundant but also seems to prevent
problems.
3. After I have everything setup, I click okay and then click the "Reset
Design" icon on the upper toolbar (Wide black oval with red arrow above it).
This step has saved me the most trouble. Sometimes after pressing this, I will
see that some of my settings didn't apply so I have to go reset them up and
click "Reset Design" again.
4. Then I usually run one complete hat or whatever first and watch for those
changes to occur while running.
Maybe this will help you out a little!
-Mike
MGB Promo LLC
Salt Lake City, UT
Running 6 Amaya XT machines with Amaya OS v9 & DesignShop v9
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================