[amayausers] Re: Machine Settings

Rod,
Old machine with new roller upgrade is sewing rings around new machine. Going 
to name new machine "wicked witch"..



TO ALL!!! If you have not upgraded your rollers, DO IT!!! Visible improvement 
in quality. 

Herb
  ----- Original Message ----- 
  From: Rod or Sharon 
  To: amayausers@xxxxxxxxxxxxx 
  Sent: Tuesday, November 22, 2005 11:12 AM
  Subject: [amayausers] Re: Machine Settings


    Herb,
    Failed to mention that yes, the new MT would/could possibly apply to any 
machine the new rollers are retrofitted to.

    Rod

    Embroidery Cottage
    Rod & Sharon Springer
    Melco Amaya Tech & Trainer
    Design Shop Pro+ Digitizing

    Boise, ID  83713
    208-938-3038
      ----- Original Message ----- 
      From: HK Acree 
      To: amayausers@xxxxxxxxxxxxx 
      Sent: Tuesday, November 22, 2005 9:24 AM
      Subject: [amayausers] Machine Settings


      Hey Group,
      Having a bit of an issue here. New machine arrived Saturday, along with 
the thread feed roller upgrade for the older machine. Upgraded OS software as 
well. Sewed some flats with both machines using the auto material thickness, 
the only issue was the new machine missed trimming the bobbin about 30% of the 
time. Then I started sewing caps on the new machine, again using the auto MT 
feature and began to install the roller upgrade on the old girl. The caps sewed 
horrible, thread breaks and fraying thread. The OS was showing the thread feed 
varying from 2 to 6 as it sewed. Turned this feature off and ran at MT of 10 
but results were not much better. Still breaking thread. 
      I mention the roller upgrade because I found the note that says the new 
rollers may require a 1-2 point higher MT to work. The question is, would the 
higher MT also apply to the new machine as well? Are my issues because I am 
running the new machine at settings that worked with the old machine/roller 
combination. Any thoughts. 


      Herb
      Royal Embroidery

GIF image

Other related posts: