[amayausers] Re: Machine Settings

From: "Rod or Sharon" <springer37@xxxxxxxxxxxx>
To: <amayausers@xxxxxxxxxxxxx>
Date: Tue, 22 Nov 2005 11:35:02 -0700

  Herb,
  Sending you a private e-mail on the side

  Rod Springer

  Embroidery Cottage
  Rod & Sharon Springer
  Melco Amaya Tech & Trainer
  Design Shop Pro+ Digitizing

  Boise, ID  83713
  208-938-3038
    ----- Original Message ----- 
    From: HK Acree 
    To: amayausers@xxxxxxxxxxxxx 
    Sent: Tuesday, November 22, 2005 9:24 AM
    Subject: [amayausers] Machine Settings


    Hey Group,
    Having a bit of an issue here. New machine arrived Saturday, along with the 
thread feed roller upgrade for the older machine. Upgraded OS software as well. 
Sewed some flats with both machines using the auto material thickness, the only 
issue was the new machine missed trimming the bobbin about 30% of the time. 
Then I started sewing caps on the new machine, again using the auto MT feature 
and began to install the roller upgrade on the old girl. The caps sewed 
horrible, thread breaks and fraying thread. The OS was showing the thread feed 
varying from 2 to 6 as it sewed. Turned this feature off and ran at MT of 10 
but results were not much better. Still breaking thread. 
    I mention the roller upgrade because I found the note that says the new 
rollers may require a 1-2 point higher MT to work. The question is, would the 
higher MT also apply to the new machine as well? Are my issues because I am 
running the new machine at settings that worked with the old machine/roller 
combination. Any thoughts. 


    Herb
    Royal Embroidery

References:

[amayausers] Machine Settings
From: HK Acree

[amayausers] Re: Machine Settings

Other related posts: