On the Hooptech system, at least the larger one, there is a -3 inch offset in the Y direction with regard to "hoop center". If this information is not entered in when creating a hoop in software, you are asking for trouble. What can happen is... you leave the Hoop tech device clamp open and then go to standard hoop center, and depending on what needle your needle case is on, the handle to the hoop tech device will push into the back of the needle case driving the needle case off it's foundation and rendering the machine useless until the needle case can be repaired or replaced by a technician. This design flaw is through no fault of Melco or Hoop tech. Just the simple fact that this is an after market product that was not designed with the Amaya in mind. Just be sure to work with this device slowly and with certainty of every step you take. Never power up the Amaya with the device on the machine and never power down with the device on the machine. Create a new hoop(s) in software to accommodate the device and if you are not sure how to do this, educate yourself by someone who does knowing completely that you take full responsibility for any and all mishaps that may arise when using this device. This device also needs to be calibrated to your machine as it doesn't simply "fit" when you slide it into the hoop arms. The reason is that this device is meant to fit all machines (or most) and has to be adjustable accordingly. Know that this is a fancy device and it does allow you to sew on a good number of items that you otherwise would not be able to sew. Hence, it falls under the category of specialized embroidery and should come with a price tag to match. A little preventive measure in case something terrible should happen, say, late at night when you (or one of your employees) aren't paying attention to what you are doing and then OOOOOPS!!!! As a tech, I've seen the aftermath before, and although it's all repairable, it's an unnecessary expense that costs way more than the price of the hoop tech device, not to mention down time. You might also void your warranty if Melco finds out because it's not an authorized Melco device. Geeze Louise - That's no good! Best of luck to all who venture forth with this and all 3rd party after market devices! Ed Orantes Amaya Tech, Trainer & Owner New Orleans, LA 504-258-6260 -----Original Message----- From: amayausers-bounce@xxxxxxxxxxxxx [mailto:amayausers-bounce@xxxxxxxxxxxxx]On Behalf Of Peachey Threads Sent: Monday, June 20, 2005 11:57 AM To: amayausers@xxxxxxxxxxxxx Subject: [amayausers] Re: Hooptech clamping system Hi Rod, I did a search using "Hoop Tech" in the search box. This came up with quite a bit. Hope that is helpful. I am following this as I purchased the TSC2. Have been using it on my Barudan. Just tried putting it on my Amaya for the first time. I can see there will be some problems with clearance.............so I am interested in whatever anyone has to say. Regards, Karen Peachey Threads Embroidery & Digitizing www.peacheythreads.com It is the Peach -----Original Message----- From: amayausers-bounce@xxxxxxxxxxxxx [mailto:amayausers-bounce@xxxxxxxxxxxxx] On Behalf Of rodswen Sent: Saturday, June 18, 2005 5:23 PM To: amayausers Subject: [amayausers] Hooptech clamping system Hello, I seem to remember a while back there was a discussion of Hooptech clamp systems on AMAYA. I have searched for it, but I am unable to locate it. Does anyone have info they are willing to share? Thanks in advance. Rod Swenson Katbird