This message was posted by Barbara Bunker on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/3/220.html#000008 OK, Ed, is there someplace other than the hoop definition where I can put in the 1.5 offset? It's greyed out in the hoop definitions. I even tried to create a new hoop definition but still couldn't change the offset. I can move the design until it appears to be centered in the hoop, but it's outside the hoop limits (on the screen it looks like there is at least two inches of hoop I can't use). If this doesn't make sense I'll send a pic when I get back home next week. Thanks much, Barb Back in the day, before the Hoop Tech Slimline hoop was available, one had to know to type in a -3 in the Y offset field when using the ICTCS hoop (the original yellow clamping hoop). I'm guessing this is where you would want to make adjustments. Maybe start with a -1.5 and see what happens. I'm going on a service call today and will see what options I have to make changes to this hoop. Let me know if the Y offset works for you. Ed Orantes =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================