Have you tried adjusting the settings for your material thickness. On some designs I sew I will need to adjust the thickness based on what is being sewn. Page 8-15 and 8-16 in the Amaya Equipment and Software Manual gives a good description on the adjusting the material thickness. Terri Hoover Embroidery Creations -----Original Message----- From: amayausers-bounce@xxxxxxxxxxxxx [mailto:amayausers-bounce@xxxxxxxxxxxxx] On Behalf Of Moore Embroidery and Designs Sent: Sunday, January 23, 2005 8:32 PM To: amayausers@xxxxxxxxxxxxx Subject: [amayausers] Re: Help Don't throw it out yet! I agree. If you do not have any of those thread feed rollers, which I am told, new ones are being Beta-sited as we speak, then swap the thread to another position and try it, especially one that has not been used very much. We have had to replace those about monthly, I'm sure you would replace them MOORE regularly if it is used MOORE! The tech manual is good about how to do it, if you have never done it before. Or hollar back at us, we'll walk you through it. Another thing to look at is the bobbin itself. Have you cleaned it lately, run some paper or thin piece of backing under the spring portion that is adjustable to clean it. I've seen lint build up under there pretty severely. Blow it out, squirt some alcohol and then adjust it to where it is a little loose. Sincerely, LiVawne G Moore Moore Embroidery & Designs 1724 Jerusalem Drive Round Rock, TX 78664 512-989-0518 Office 512-632-7826 Cell Moore-Embroidery@xxxxxxxxxx www.Moore-Embroidery.com -----Original Message----- From: amayausers-bounce@xxxxxxxxxxxxx [mailto:amayausers-bounce@xxxxxxxxxxxxx]On Behalf Of D Stitch Sent: Sunday, January 23, 2005 7:01 PM To: amayausers@xxxxxxxxxxxxx Subject: [amayausers] Re: Help I would check your feed rollers first. With my machine as soon as my feed rollers start to wear down I start getting a lot of false bobbin breaks. Dianne D-Stitch Embroider -----Original Message----- From: amayausers-bounce@xxxxxxxxxxxxx [mailto:amayausers-bounce@xxxxxxxxxxxxx] On Behalf Of Bulkley Cleaners Sent: Sunday, January 23, 2005 4:59 PM To: Amayausers@xxxxxxxxxxxxx Subject: [amayausers] Help I am very new to this. Bought an Amaya in October. I am having huge trouble's with false bobbins break's. It seem's if the design's calls for long run's from left to right and back again, it give's false bobbin break.s Do some fills have more trouble than other's? I'm ready to throw the machine out the back door. Been fighting with this for 4 day's now. Thank you in adcance. Terry Bulkley Cleaners Smithers BC