[amayausers] Re: HELP!!! "Ethernet communications did not start correctly"

            Jack,
                    Not sure if this is going to help, the crossover cable must
go from the NIC in the computer directly to the Amaya, the conventional Melcos
require IPS/SPX, and under the ADVANCED tab the FRAME TYPE needs to be set to
ETHERNET 802.3.

                            Mike Wargo
                            Fox Hill

Jack Peckham wrote:

> Hi, I just recieved my AMAYA friday afternoon. By the time I got it set up,
> tech support had closed.
> Does anyone know the network protocol?
> Does it run TCP/IP? what IP address.
> It does not show up on my routers DHCP list.
>
> It came with a crossover cable. I tried hooking it up straight into my NIC &
> got a light, but I get a message ?Ethernet communications did not start
> correctly, restart computer" I did & still got the massage. Therefore, I
> hooked up my router with patch cables. Same problem. When I hooked up the
> router, I went into it & looked at the DHCP list, no AMAYA. I thought I may
> have a NIC card problem, so I put in a card from an old computer & I still
> have the problem, so I am assuming I need to set up something in the network
> protocols so the AMAYA can be seen???
>
> HELP!!!
>
> Thanks,
> Jack Peckham
> Greyt Threads
>
> jack@xxxxxxxxxxxxxxx
> web site www.idyllhounds.com
>
> _________________________________________________________________
> Tired of spam? Get advanced junk mail protection with MSN 8.
> http://join.msn.com/?page=features/junkmail
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: amayausers-unsubscribe@xxxxxxxxxxxxxxxx
> For additional commands, e-mail: amayausers-help@xxxxxxxxxxxxxxxx


---------------------------------------------------------------------
To unsubscribe, e-mail: amayausers-unsubscribe@xxxxxxxxxxxxxxxx
For additional commands, e-mail: amayausers-help@xxxxxxxxxxxxxxxx

Other related posts: