This message was posted by Digital Stitchz / LaserWorkz on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/11/11.html#000012 Jean, I do not believe 340 degrees for 8 to 10 seconds is too hot for the poly (dazzle) fabric. You can move the heatpress down in temp to 320 ort 330 and add some pressure and/or time. Like 320 degrees for 12 to 14 seconds. But you should not have any problems. If you can, always test/emperiment first because some poly fabrics can not stand too much pressure. I hope this helps. Lee @ Digital Stitchz =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================