[amayausers.com] Re: FrastFrame Z axis problem

This message was posted by Dave on AmayaUsers.com. PLEASE DO NOT REPLY VIA 
EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: 
http://www.amayausers.com/boards/ultimatebb.php?/topic/1/322.html

When I place the ff in my Amaya XT, I cannot get the Z axis to move back so as 
to access the sewing field.  The frame points OUT and the head does not move in 
far enough to access sewing field. It's almost like the frame was built 
backwards or my head should move more?

If I hit the E stop I can move the head back by hand ; however, when I turn the 
E stop off and try to move the head it only moves out, until it is centered 
again?

Any ideas?

Thanks, Dave

=========================================================== 

The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list

===========================================================

Other related posts: