Guessing you need a service call and that your belts need to be retensioned. That's my initial thought at least on what could cause the same design to sew out differently on two amayas. John -----Original Message----- From: amayausers-bounce@xxxxxxxxxxxxx [mailto:amayausers-bounce@xxxxxxxxxxxxx] On Behalf Of Debra Hahn Sent: Friday, August 25, 2006 11:04 AM To: amayausers@xxxxxxxxxxxxx Subject: [amayausers] Re: Desnity differences between machines despite same settings Dear Amaya users! I'm hoping that someone can point me in the right direction before I have to call a tech to come out to service one of my Amaya machines. I own two Amayas and frequently use them both on the same order...however in the last month one of the Amayas sews out all of the column stitches SIGNIFICANTLY heavier than the other Amaya. The density is set the same on both machines...and I'm loading the same design... They both sew out the logos without problems but I can't use both machines on the same job because the logos look too different (sigh).=20 Any ideas? Debby Hahn Coyote Design, Inc. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list =========================================================== =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================