[amayausers] Re: Caps - low profile parts

Your Amaya should have come with a right angled flat blade screwdriver which
is used to loosen the finger screws and the needle plate, make sure you
tighten the cap framewith  the screwdiver once you have installed it
otherwise the viabration causes the screws to work loose and end up messing
up the Garmets or hats your working on ( I speak from experience and an
expensive one)

Regards

Tony
ChilmarkUK
----- Original Message -----
From: "Captain Gold" <captaingold@xxxxxxxxxxxxx>
To: <amayausers@xxxxxxxxxxxxxxxx>
Sent: Tuesday, March 16, 2004 3:59 PM
Subject: [amayausers] Caps - low profile parts


> Help! Can someone tell me how I'm supposed to loosen the four screws that
> hold on the cap supports on the driver? I'd like to put the supports for
> the low profile caps on, but I can't unscrew the four thumb screws. They
> came from the factory so tight that I can't budge them. I don't want to
use
> a wrench for fear of damage.
>
> Thanks,
> Connie Bechtel
>
>
> Wyvern Productions
> Custom embroidery for the custom mind.
> http://www.wyvernproductions.com
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: amayausers-unsubscribe@xxxxxxxxxxxxxxxx
> For additional commands, e-mail: amayausers-help@xxxxxxxxxxxxxxxx
>



---------------------------------------------------------------------
To unsubscribe, e-mail: amayausers-unsubscribe@xxxxxxxxxxxxxxxx
For additional commands, e-mail: amayausers-help@xxxxxxxxxxxxxxxx

Other related posts: