This message was posted by Barbara Bunker on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/2/256.html#000001 It would be best if you could use the same thread in the bobbin and I think it would work best as follows: 1. Running stitch for placement, then applique command. 2. Spray a little KK2000 (or equal) on the wrong side of two fabric pieces then smooth them out, one on top and one underneath. 3. Another stitch-down running stitch, then another applique command. 4. Carefully take hoop off machine and trim close to edges on both top and bottom. 5. Place hoop back into machine and finish with a satin stitch. It would look the best if you can wind a bobbin with the same thread as used on top. Hope this helps. Barb in Broomfield, Colorado =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================