[accessibleimage] Re: QuickTac and VersaPoint question

Hi, Lisa,
Oh. I always emboss it from Duxbury so I don't know. But I recently
discovered the manual form the Versa point and it mentions something about a
graphics mode for the VersaPoint which leads me to think you are on to
something. If you still have your manual I would check it or otherwise try
the company. I guess they were taken over by Freedom Scientific. Maybe Gayle
Yarnell at Adaptive Technology Consultants can help you. Sorry I can't tell
you more.
Sherry


> Hi Sherry,
> I'm using TSI VersaPoint. I sort of wonder if it has to do with the
> embossers set up but am unsure. It works OK when I insert it in a
> Duxbury file. But I would also like to emboss it directly from QuickTac.
> On a Juliet it works fine so that is also why I think it might have to
> do with the embosser set up. Any ideas about embosser settings?
> Thanks,
> Lisa
> 
> Sherry Leffert wrote:
>> 
>>     HI, Lisa,
>>     I use Quick Tac beta with an old VeraPoint Duo and it is working
>>     really well. I did have that problem once and I think it was
>>     because the picture was too big or because I had words on the page
>>     before it and it couldn¹t fit on the same page.
>>     I love the Quick Tac beta and have been able to make some great
>>     math graphics on it.
>>     Sherry Leffert
>>     Cambridge, MA
>> 
>>     Hi,
>> 
>>     I have a question about using a VersaPoint and QuickTac
>>     betaversion and hoping someone might have an idea.
>>     When printing out a graphic directly from QuickTac the picture
>>     divides into parts. First a bit of the graphic embosses than it
>>     spaces down for about 5 inches then embosses a bit then spaces
>>     again etc.
>>     I think this is a hardware/firmware problem but not sure. Any
>>     ideas? Any help would be appreciated.
>> 
>>     Thanks,
>>     Lisa
>> 
>>     Lisa Yayla
>>     Huseby Kompetansesenter
>>     Oslo Norway
>>     lisa.yayla@xxxxxxxxxx
>> 
>> 
>> 
>> 
>>     Lisa Yayla
>>     Huseby Kompetansesenter
>>     Oslo Norway
>>     lisa.yayla@xxxxxxxxxx
>> 
>> 
>

Other related posts: