[access-uk] setting paper length in everest

        Hello,

I need to set the paper length on an everest embosser.  A4 is 295 CM 
or thereabouts i think.  The value key increases the value up to 
about five hundred, but doesn't wrap back to it's starting 
value.  How do I get the value to decrease when it has reached it's 
maximum?  would I use 295 by 210 CM for a4 paper? I do not see a 
reference for reducing these values in the manual

Thanks for any assistance with this.
.
Many thanks.
Joe Paton

** To leave the list, click on the immediately-following link:-
** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** access-uk-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click on the
** immediately-following link:-
** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to
** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq

Other related posts: