
|
[si-list]
||
[Date Prev]
[11-2006 Date Index]
[Date Next]
||
[Thread Prev]
[11-2006 Thread Index]
[Thread Next]
[SI-LIST] Re: Buffer delay
- From: "Lynne D. Green" <lgreen22@xxxxxxxxxxxxxx>
- To: <forsilist@xxxxxxxxx>, <yang@xxxxxxxxxx>, <si-list@xxxxxxxxxxxxx>
- Date: Fri, 17 Nov 2006 11:35:42 -0800
Hello, Yan Hang,
IBIS and SPICE do not have the same Time=0 reference, due to the way SI
tools trigger I/O inputs. This means that there is a time offset between
the two waveforms.
This offset can be corrected for by simulating the load [Vmeas, Rref, Cref].
This delay offset can then be used to adjust the delay in other simulations.
Many SI tools have automated this process.
A good paper on this is http://pcdandm.com/cms/content/view/2800/95/. There
is also a HyperLynx Application Note, referenced in that paper.
Best regards,
Lynne
"IBIS training when you need it, where you need it."
Dr. Lynne Green
Green Streak Programs
http://www.greenstreakprograms.com
425-788-0412
lgreen22@xxxxxxxxxxxxxx
-----Original Message-----
From: si-list-bounce@xxxxxxxxxxxxx [mailto:si-list-bounce@xxxxxxxxxxxxx] On
Behalf Of raj singh
Sent: Friday, November 17, 2006 1:34 AM
To: yang@xxxxxxxxxx; si-list@xxxxxxxxxxxxx
Cc: liuweidong@xxxxxxxxxx
Subject: [SI-LIST] Re: Buffer delay
Hspice delays should be accurate and in general more than ibis. Better to
use ibis only for SI sims and not for timing.
regards
Raj
yan hang <yang@xxxxxxxxxx> wrote:
Hi All,
Now I do some board timing simulations . I got the hspice = model and ibis
model for same buffer. Then I set a test fixture(Ex.
Cref=3D15pf,Rref=3D1E6,Vref=3D3.3V),I contrast the simulation result of =
buffer dealy using hspice model and ibis model. I found there is a little
big diffrence between them.
So when translate hspice model to ibis model,how to consider about the
buffer deley issue? =20 Should I trust the buffer delay value from ibis
model = simulation?
Best Regards.
Yan Hang
Huawei Technology
086-21=A3=AD68644808=A3=AD24043
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List FAQ wiki page is located at:
http://si-list.org/wiki/wiki.pl?Si-List_FAQ
List technical documents are available at:
http://www.si-list.org
List archives are viewable at:
http://www.freelists.org/archives/si-list
or at our remote archives:
http://groups.yahoo.com/group/si-list/messages
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu
|

|