FreeLists / si-list / [SI-LIST] 60MHz Bus: PCB trace length

[S Balaji <S.Balaji@xxxxxxxxxxxx>]

Hi Guys,
I have a 32-Bit processor interfaced to an ULPI tranceiver.
The bus is at 60Mhz.

One of the control signal from the processor (STP) is more in length by 
300mils w.r.t the clock.
The total length of the line is 1700mils. No termination. Stripline 
routing.

If i set the STP pin at slow slew rate (Processor pin configuration), then 
my USB communication fails. 
The CRC is detected wrongly (Data is correct. )

But if i set the STP pin at fast slew rate, it works fine.

Question
1. Is 300mils increase a major factor? 
    Set up time requirement is 4.5ns. I could not get any info on the rise 
time.

Regards
Balaji S


------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field


List technical documents are available at:
                http://www.si-list.net

List archives are viewable at:     
                http://www.freelists.org/archives/si-list
or at our remote archives:
                http://groups.yahoo.com/group/si-list/messages
Old (prior to June 6, 2001) list archives are viewable at:
                http://www.qsl.net/wb6tpu