FreeLists / si-list / [SI-LIST] Re: Serpentine Traces

["Ingraham, Andrew" <Andrew.Ingraham@xxxxxx>]

> To answer Andy's question, I click Info in Allegro - which I believe 
> measures the center of the line.
 
That's really the question ... do all the various CAD tools all use the
same algorithm?  Is there a standard?  What do you call the "center of
the line" when going around a bend?

I figure it might be enough of a difference to add up after going
through a hundred or so bends.  Then again, the manner in which a board
chamfers its corners might add up after a hundred of them, too.

Regards,
Andy



------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field

List archives are viewable at:     
                http://www.freelists.org/archives/si-list
or at our remote archives:
                http://groups.yahoo.com/group/si-list/messages 
Old (prior to June 6, 2001) list archives are viewable at:
                http://www.qsl.net/wb6tpu