FreeLists / si-list / [SI-LIST] Re: pspice

[Vijay Boddu <Vijaya.Boddu@xxxxxxx>]

Hi pietro,

In Pspice there is a gnd_earth symbol which you should 
use to be referenced to node0.Since you AC coupling capacitor 
in your circuit pspice may complain that there is no dc path to 
ground. So you can connect a large value of resistor in 
parallel.


Thanks
vijay


>I just started using Orcad Capture student. My schematic is just a
>simple example from a course homework to get used to capture and pspice.

>I have one VPULSE that connect to a R C in series. But whenever I try to
>run the simulation I got the following messages 


>ERROR - Node xxxxx is floating
>ERROR - Node xxxxx is floating
>ERROR - Node GND is floating

>I have verified over and over again that all my elements are connected
>by wires and in fact if I disconnect one of them I got an error message
>that is different (unconnected net)

>Could someone help me with this problem ? I have checked all parameters
>but cannot figure out what this "floating" node mean.

>Any help would be appreciated.

>Thanks.


>Pietro



~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Vijaya Kumar Boddu
Sun Microsystems
ph   : 408-616-5862 (x45862)
Email: vijaya.boddu@xxxxxxx
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~


------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field

List archives are viewable at:     
                http://www.freelists.org/archives/si-list
or at our remote archives:
                http://groups.yahoo.com/group/si-list/messages 
Old (prior to June 6, 2001) list archives are viewable at:
                http://www.qsl.net/wb6tpu