FreeLists / si-list / [SI-LIST] PSPICE

[Pietro Maffei <maffei@xxxxxxx>]

Hi,

I just started using Orcad Capture student. My schematic is just a
simple example from a course homework to get used to capture and pspice.

I have one VPULSE that connect to a R C in series. But whenever I try to
run the simulation I got the following messages 


ERROR - Node xxxxx is floating
ERROR - Node xxxxx is floating
ERROR - Node GND is floating

I have verified over and over again that all my elements are connected
by wires and in fact if I disconnect one of them I got an error message
that is different (unconnected net)

Could someone help me with this problem ? I have checked all parameters
but cannot figure out what this "floating" node mean.

Any help would be appreciated.

Thanks.


                Pietro
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field

List archives are viewable at:     
                http://www.freelists.org/archives/si-list
or at our remote archives:
                http://groups.yahoo.com/group/si-list/messages 
Old (prior to June 6, 2001) list archives are viewable at:
                http://www.qsl.net/wb6tpu