
|
[si-list]
||
[Date Prev]
[08-2001 Date Index]
[Date Next]
||
[Thread Prev]
[08-2001 Thread Index]
[Thread Next]
[SI-LIST] Re: VGA/VIDEO: IMPEDANCE & LENGTH
- From: stephanie.k.goedecke@xxxxxxxxxxxxxx
- To: lmiller@xxxxxxxxxxxxxxxxxxxx, chandan_career@xxxxxxxxx,si-list@xxxxxxxxxxxxx
- Date: Wed, 1 Aug 2001 13:55:12 -0700
No, it doesn't include that. And some video standards are to 1V p-p.
I think this is the standard Chandan was asking about.
-Stephanie
> -----Original Message-----
> From: Larry Miller [SMTP:lmiller@xxxxxxxxxxxxxxxxxxxx]
> Sent: Wednesday, August 01, 2001 1:42 PM
> To: Goedecke, Stephanie K; chandan_career@xxxxxxxxx;
> si-list@xxxxxxxxxxxxx
> Subject: RE: [SI-LIST] Re: VGA/VIDEO: IMPEDANCE & LENGTH
>
> Does the RGB 0.700v include the blanking pedestal? I thought that brought
> the whole shebang up to 1 v p-p.
>
> Larry Miller
>
> -----Original Message-----
> From: stephanie.k.goedecke@xxxxxxxxxxxxxx
> [mailto:stephanie.k.goedecke@xxxxxxxxxxxxxx]
> Sent: Wednesday, August 01, 2001 1:19 PM
> To: chandan_career@xxxxxxxxx; si-list@xxxxxxxxxxxxx
> Subject: [SI-LIST] Re: VGA/VIDEO: IMPEDANCE & LENGTH
>
>
>
> The HSYNC and VSYNC signals have TTL levels. I often see 300-1k ohm
> series resistors on them.
>
> The analog R,G and B should be 75ohms. The maximum voltage should be
> 0.700 Volts + 0.07 Volts/-0.035 Volts
>
> You can get the VSIS standard from
>
> Video Electronics Standards Association
> 920 Hillview Court, Suite 140
> Milpitas, CA 95035
> 408-957-9270
>
>
> > -----Original Message-----
> > From: Chandan [SMTP:chandan_career@xxxxxxxxx]
> > Sent: Wednesday, August 01, 2001 9:24 AM
> > To: SI FORUM
> > Subject: [SI-LIST] VGA/VIDEO: IMPEDANCE & LENGTH
> >
> >
> > Hi everybody,
> >
> > The video interface between a motherboard & a monitor
> > typically consists of the following signals:
> > 1. RED, GREEN & BLUE
> > 2. HSYNC, VSYNC etc.
> >
> > My questions:
> > 1. Are there specifications for the characteristic
> > impedance of these signals? For e.g., the USB
> > specification defines the characteristic impedance
> > with which the USB signals must be routed with.
> > I'm not too sure, but I think that the RED, GREEN &
> > BLUE lines must be routed with a characteristic
> > impedance of 37.5 ohms, whereas the HSYNC & VSYNC
> > signals must be routed with a trace of characteristic
> > impedance of 40 ohms. Could someone clarify please.
> >
> > 2. Are there specifications for the maximum length of
> > these signals?
> > As of now, I think that the length on the motherboard
> > really does not matter. This is because, after the
> > signals leave the motherboard, the cable that connects
> > to the monitor is at least a foot in length. PLease
> > comment.
> >
> > Thanks,
> > Chandan
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Make international calls for as low as $.04/minute with Yahoo! Messenger
> > http://phonecard.yahoo.com/
> > ------------------------------------------------------------------
> > To unsubscribe from si-list:
> > si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
> > For help:
> > si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
> >
> > List archives are viewable at:
> > http://www.freelists.org/archives/si-list
> > or at our remote archives:
> > http://groups.yahoo.com/group/si-list/messages
> > Old (prior to June 6, 2001) list archives are viewable at:
> > http://www.qsl.net/wb6tpu
> >
> ------------------------------------------------------------------
> To unsubscribe from si-list:
> si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
> For help:
> si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
>
> List archives are viewable at:
> http://www.freelists.org/archives/si-list
> or at our remote archives:
> http://groups.yahoo.com/group/si-list/messages
> Old (prior to June 6, 2001) list archives are viewable at:
> http://www.qsl.net/wb6tpu
>
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List archives are viewable at:
http://www.freelists.org/archives/si-list
or at our remote archives:
http://groups.yahoo.com/group/si-list/messages
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu
|

|