FreeLists / si-list / [SI-LIST] Regarding the air gap between via hole and copper

["Pang Ning" <pangning2000@xxxxxxxxx>]

Dear Experts,

I have a simple question about the gap between the via hole pad and 
surrounding copper. In VCC layer, I used positive plane. Because the board 
size is small, in order to give wider spacing for power between via holes, I 
used 5mil air gap between via pad and the copper. I don't know whether this 
spacing(5mil) will cause some problems such as crosstalk from via holes, low 
yield issue... Is 5mil too small for the gap? Could you give me some 
suggestions if you think there is anything wrong?

Thanks,
Peter 

------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field

List FAQ wiki page is located at:
                http://si-list.org/wiki/wiki.pl?Si-List_FAQ

List technical documents are available at:
                http://www.si-list.org

List archives are viewable at:     
                http://www.freelists.org/archives/si-list
or at our remote archives:
                http://groups.yahoo.com/group/si-list/messages
Old (prior to June 6, 2001) list archives are viewable at:
                http://www.qsl.net/wb6tpu