FreeLists / si-list / [SI-LIST] DDR point to point termination

["Aric Hadav" <arich1970@xxxxxxxxxxx>]

Hi,

I'm designing an embedded system with DDR. I'm using a CPU connected to an 
on board four 16 bit DDR devices (no DIMM).
I have 2 questions though -
1. can I use only a series termination on the data bus (I saw a few AN that 
state that if the disctance between the controller and the DDR IC's is upto 
2" its ok). has anyone did it with a 200MHz clock ?
2. since the address and control lines operate in half the data rate and the 
DDR controller is very  lightly loaded (only 4 chips) can I use only series 
termination for address and control ? has anyone did it with good resaults ?

thanks,

  Aric

_________________________________________________________________
Add photos to your messages with MSN 8. Get 2 months FREE*. 
http://join.msn.com/?page=features/featuredemail

------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field

List FAQ wiki page is located at:
                http://si-list.org/wiki/wiki.pl?Si-List_FAQ

List technical documents are available at:
                http://www.si-list.org

List archives are viewable at:     
                http://www.freelists.org/archives/si-list
or at our remote archives:
                http://groups.yahoo.com/group/si-list/messages
Old (prior to June 6, 2001) list archives are viewable at:
                http://www.qsl.net/wb6tpu