FreeLists / si-list / [SI-LIST] Modeling a MUX/DEMUX?

["Aspnes, Brian D" <brian.d.aspnes@xxxxxxxxx>]

If you wanted to model the IDT MUX parts IDTQS3VH257 and IDTQS3VH253 =
for
pre-layout simulations, in a series net configuration [such that the
MUX/DEMUX is in series with your trace ("Y" to "In", with select and =
enable
"on")], how would you model the MUXs with a Single Line Lumped Model =
"SLM"
type environment (we use Innoveda Scratchpad/ePlanner which uses .ibs =
models
and "schematic" versions of connectors/bus switches). =A0

Driver -> Trace -> MUX/DEMUX -> Trace -> Receiver=20
=A0
Does anyone have a Single Line Lumped Model (SLM with one input, one =
output)
that I can use for signal integrity analysis similar to this connector =
model
from AMP (Mictor): =
http://www.amp.com/simulation/scripts/models.asp#list=20
=A0
Brian Aspnes
Intel Communications Group (ICG)
E-mail: brian.d.aspnes@xxxxxxxxx
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field

List archives are viewable at:     
                http://www.freelists.org/archives/si-list
or at our remote archives:
                http://groups.yahoo.com/group/si-list/messages 
Old (prior to June 6, 2001) list archives are viewable at:
                http://www.qsl.net/wb6tpu