[pure-silver] Re: sheet film and keeping a sequence straight
From: "Richard Knoppow" <dickburk@xxxxxxxxxxxxx>
To: <pure-silver@xxxxxxxxxxxxx>
Date: Sat, 2 Jun 2007 15:44:44 -0700
----- Original Message -----
From: "Shannon Stoney" <shannonstoney@xxxxxxxxxxxxxxx>
To: <pure-silver@xxxxxxxxxxxxx>
Sent: Saturday, June 02, 2007 3:25 PM
Subject: [pure-silver] sheet film and keeping a sequence
straight
As usual I forgot something. I think you could make the
transparent numbers using a computer printer on transparency
material. Print an array and cut them up. They are mounted
on the edge of the film channel near the dark slide end of
the holder with a drop of glue. The holder must be marked on
the outside with the corresponding number. The number tabs
on the holders I have are about 1/8th inch wide. They should
be oblong rather than square so that they extend over the
film rail.
Grafmatic holders also number each negative by using a
number wheel but the numbers are for the individual holder.
---
Richard Knoppow
Los Angeles, CA, USA
dickburk@xxxxxxxxxxxxx
=============================================================================================================
To unsubscribe from this list, go to www.freelists.org and logon to your
account (the same e-mail address and password you set-up when you subscribed,)
and unsubscribe from there.
