Very simple board... small, 4 layers.
Using 15.2
Fill is on, and is dynamic. With the
Global parameters set to Gerber 4x00, the fill and voids show up and
the fill fills. Works fine.
Change the Global parameters to Gerber 6x00
and the fill works fine, the boundry is visible and all is well.
Change to 274X and the fill, only on the
top layer, suddenly goes away. (the other layers work fine) The
boundry data is still present, I can see the outlines and the voids,
but there is now no fill. Worst yet, now, when I go to artwork
parameters... I am prompted to update the fill... which does nothing,
it reports just fine, it just is not there. And of course I cannot go
on as the artwork says fill needs to be updated.
Fill fails for anything except Gerber 4x00
or 6x00.
Anybody have a clue as to what the key
might be here? Strange one I tell ya. Very strange.
-----------------------------------------------------------
To subscribe/unsubscribe:
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe
To view the archives of this list go to http://www.freelists.org/archives/icu-pcb-forum/
Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
