I'd need more detailed info. I have /etc/modules.conf file I'm opening it and adding "alias ne eth0" then what????????? -NUrj Thanx > > Most likely, you are talking about a PnP ISA ethernet card. If this is the > case, you should have a diskette from the manufacturers that lets you set the > card parameters (the equivalent to using jumpers in "the old days"). You will > have to use this disk to set the card to a specific address (you'll probably > have to boot into DOS to use it). It shouldn't matter what address, as long > as > it's not PnP. Then, kudzu should hopefully find it on the next boot. if not, > you'll have to edit the /etc/modules.conf or /etc/conf.modules and add: > > alias ne eth0 > options eth0 io=0x300 > > set the io to whatever address you set the card to. > > Hope this helps out. > > --Ben Chavet > > > Quoting Nurzhan Ustemirov <nustemir@xxxxxxxxxxx>: > > > > > is there any simple way to configure ISA ethernet? I'm using RH 7.1 > > Thanx > > -Nurj > > > > > > ---- > > Husker Linux Users Group mailing list > > To unsubscribe, send a message to huskerlug-request@xxxxxxxxxxxxx > > with a subject of UNSUBSCRIBE > > > > > > > > > ------------------------------------------------- > This mail sent through IMP: http://horde.org/imp/ > > ---- > Husker Linux Users Group mailing list > To unsubscribe, send a message to huskerlug-request@xxxxxxxxxxxxx > with a subject of UNSUBSCRIBE > > > > ---- Husker Linux Users Group mailing list To unsubscribe, send a message to huskerlug-request@xxxxxxxxxxxxx with a subject of UNSUBSCRIBE