FreeLists / haiku-development / [haiku-development] Re: AMD Geode nano-size motherboard

["scott mc" <scottmc2@xxxxxxxxx>]

I put the IDE flash drive onto the 44-pin IDE header and booted up
Haiku.  I then went to DriveSetup and initilized it with a Be File
System.  I then ran the Installer and waiting for it to end, well it
never says it ends, so I just waited until 5 minutes after it said
"finishing...".
I then tried running makebootable like I did on the CF card, but this
time I got an error.

Here's the text from terminal:

/boot/beos/bin>makebootable /Haiku-IDE-Flash
Error: Failed to get partition info: Invalid Argument
/boot/beos/bin>df
Mount           Type      Total     Free     Flags   Device
--------------- -------- --------- --------- ------- --------------------------
/boot           bfs         100.0M     10.3M QAM-P-W /dev/disk/ata/0/master/raw
/Haiku-IDE-Flash
                bfs           3.8G      3.7G QAM-P-W /dev/disk/ata/0/slave/0
/boot/beos/bin>makebootable /dev/disk/ata/0/slave/0
Error: Block devices not supported on this platform!
/boot/beos/bin>

Ingo made change r24972 an hour or so after I built my current image,
so not sure if that would have fixed this issue or not.  I can give it
a try again tomorrow if that would make any difference.
http://dev.haiku-os.org/changeset/24972
-scottmc