Jennifer,
Are there any streets in between your POIs? When the GPS software creates
a route from point A to B, it looks for the best streets to get you
there. If the area where you want to create a route lies on an area that
isn't mapped out, then you will receive an error message.
Instead of an automatic route, you will have to create a manual route in
this case. So you would have to walk the desired route between the two
POIs and mark the waypoints manually by pressing the command SPACE with K
(or dot 2 with the Braille keyboard), then type in the waypoint
description and press enter.
Hope this helps,
Kim Casey
Sendero Group LLC
At 10:13 AM 8/11/2005, you wrote:
Hi All,
Is it possible to set a route from point of interest to point of
interest? On the Santa Rosa Junior college campus various buildings are
marked (without addresses). I tried to set a route from the book store
to Analy Village with no luck Why didn't this work?
Jennifer Frazier
--
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.10.6/69 - Release Date: 8/11/2005