[gps-talkusers] Re: creating and following a manual route
From: vincent <vinnroc@xxxxxxxxxxxxx>
To: gps-talkusers@xxxxxxxxxxxxx
Date: Thu, 09 Mar 2006 08:04:59 -0500
Does the same apply in a vehicle route?
----- Original Message -----
From: "Michael May" <mikemay@xxxxxxxxxxxxxxxx>
To: <gps-talkusers@xxxxxxxxxxxxx>
Sent: Thursday, March 09, 2006 12:06 AM
Subject: [gps-talkusers] Re: creating and following a manual route
> Kevin,
>
> Create an automatic route. Then, walk to the places where you want
> manual points and record them accordingly. Save the route. You may
> need to use the route editting to adjust the sequence of points. Of
> course, when you are recording manual points, make sure you have a
> steady direction of travel before pressing Chord K to record the
> point because you will be asked for a to designate, Straight, Left or
> Right. If your heading is bad, those turning directions will be bad.
>
> Mike
> At 08:28 PM 3/8/2006, you wrote:
> >Mike,
> >Can you give me instructions on creating manual points and
> >integrating it into a automatic route so that it will be all in one
piece.
> >Thanks
> >Kevin
> >
> >----- Original Message ----- From: "Michael May"
<mikemay@xxxxxxxxxxxxxxxx>
> >To: <gps-talkusers@xxxxxxxxxxxxx>
> >Sent: Wednesday, March 08, 2006 10:12 AM
> >Subject: [gps-talkusers] Re: creating and following a manual route
> >
> >
> >>Kevin,
> >>
> >>You can add manual points to an automatic route so you can have it
> >>all in one piece.
> >>
> >>Mike
> >>
> >>At 04:21 PM 3/7/2006, you wrote:
> >>>Dear Listers:
> >>>I have a question about creating a manual route for areas that are
> >>>not currently mapped according to the most recent maps which is
> >>>the 2004 maps. I have already created a route with entering all of
> >>>the Waypoints and naming them to what I wanted to name it,
> >>>and saved it and tried walking it to make sure that everything
> >>>worked out the way that I expected. So I was wondering if it was
> >>>necessary when walking or driving the route does it need to be
> >>>done in two parts. For ex: Creating a route to the point where
> >>>you began your manual route by using the comercial map, then
> >>>once you get to the point where you began making your manual route
> >>>you would open the manual route you created. Or is it possible
> >>>to just have the route open and make the route to the area that
> >>>is unmapped all in one step and have the comercial route and
> >>>the manual route link together automatically.
> >>>Well if it is possible to do it one step and it isn't the way
> >>>that I described above, can you please tell me the way that will
> >>>allow me to do this in one step.
> >>>Thank you very much.
> >>>Kevin
> >>
> >
> >
>
>
