[softwarelist] Re: Tab settings granularity

["John Grogan" <johngrogan@xxxxxxxxxxxx>]

> In message <481F7105.60904@xxxxxxxxxxxxxxxx>, Michael Ben-Gershon 
> <mybg@xxxxxxxxxxxxxxxx> writes
> > Is there any way to set tabs at intervals which do not fall on exact 
> > millimeter boundaries? I have tried entering a value (say, 41.5mm) in the 
> > dialogue box but it gets truncated to 41mm later.
> Hmm. that is probably a bug, at some point, someone had the bright idea 
> that tabs should snap to mm boundaries.
> I think you can set tabs where you want e.g. 49.5 mm, the tab stops there 
> until you select it, when the dialogue snaps it to the nearest mm.
> So you can set them via the dialogue or DDL.
Setting non-integral mm tab stops in the dialogue works fine for me on the 
Iyonix.  They even stay put if I select them on the slider.  As you suggest, 
however, if I move them using the slider, I can only move them to integral 
mm positions (which I don't consider to be a bug!).
Regards
John Grogan 

To unsubscribe or subscribe goto: http://www.freelists.org/list/davidpilling

• References:
  • [softwarelist] Tab settings granularity
    • From: Michael Ben-Gershon
  • [softwarelist] Re: Tab settings granularity
    • From: David Pilling

Other related posts:

[softwarelist] Tab settings granularity

[softwarelist] Re: Tab settings granularity

[softwarelist] Re: Tab settings granularity

[softwarelist] Re: Tab settings granularity