A Keynote SA should work under windows. If you want to have it work under
win NT (nt/2k/xp) you need to donwload the appropriate 32bit driver from
the humanware/Pulsedata website. it can be found somewhere in the
Braillenote support download section, the page where all the firmware
upgrade for the BN's can be downloaded from.
I have had my Keynote SA since 1998 and am not aware of there having been
any firmware upgrades for it during that time. IN fact, I never heard that
the Keynote's chip was flashable.
hth
Doris
At 10:52 AM 7/4/2006 +0100, you wrote:
Hi all,
Has anyone anywhere got relevant software and performed these upgrades for
the Keynote in order that it will work successfully with Windows and
faster computers. Currently selling a couple of ours, I have run into
this problem and remember only doing one upgrade, once, early with the
synth in DOS. In those days I really didn't know whether the upgrade had
taken or not.
Any information (hand holding) anyone can give on this would be more than
welcome. Thanks!
--
Carol
cdp49a@xxxxxxxxxxxx
** To leave the list, click on the immediately-following link:-
** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** access-uk-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click on the
** immediately-following link:-
** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to
** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq
--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.394 / Virus Database: 268.9.8/381 - Release Date: 7/3/2006
--
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.1.394 / Virus Database: 268.9.8/381 - Release Date: 7/3/2006
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.1.394 / Virus Database: 268.9.8/381 - Release Date: 7/3/2006
** To leave the list, click on the immediately-following link:-
** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** access-uk-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click on the
** immediately-following link:-
** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to
** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq
